How To Operate The Water Tank Wire Drawing Machine Safely?

The main contents of the safe operating procedures for water tank wire drawing machines are as follows:
(1) Before starting the water tank wire drawing machine, necessary inspections must be carried out, including its various parts and the overall lubrication condition. If there are any problems, they should be dealt with in time and the machine cannot be started.
(2) Before starting the I-wheel take-up machine, the air pump must be turned on first, and then the air pressure etc. should be checked to see if there are any problems. The I-wheel can only be installed after checking that there are no problems, otherwise it cannot be carried out. Moreover, to replace the I-shaped wheel, you must first press the reset button of the frequency converter. This step cannot be ignored.
(3) Before starting the wire drawing machine, it should be run at low speed to observe the operation of the equipment. If everything is normal, the running speed can be increased, otherwise it cannot.
(4) If an abnormality occurs during the operation of the wire drawing machine, it should be stopped immediately for maintenance to avoid amplifying the consequences.
(5) It is strictly forbidden to operate the wire drawing machine when it is sick, as this will seriously damage the equipment.
(6) When the equipment is shut down normally, the speed control button should be rotated to the medium-low speed position first.
(7) When the equipment is running, operators cannot stand in the dangerous area, let alone do some dangerous actions.