Key Points For Using Cold Rolled Ribbed Steel Bar Forming Machine

1) During operation, care should be taken to avoid knotting and disordering of the coiled steel bars.
2) The wear of the guide mold, rust removal roller and stress relief roller should be checked frequently, replaced in a timely manner, and the oxide scale should be removed regularly.
3) Lubricant and coolant should always be kept sufficient.
4) Regularly check the damage of the transmission system and replace and repair it in a timely manner.
5) All lubricated parts should be cleaned regularly and lubricated.
6) Before starting the machine, check whether all components and working switches are in the normal working position and whether the screws are loose.
7) Coolant and lubricant should be supplied before the cold rolling mill works.
8) When adjusting the pressing, it is strictly forbidden to contact or collide with each other between the rollers. The pressing rollers should be fine-tuned and there should be a gap between the rollers, otherwise the rollers will be damaged.
9) When replacing the roll sheet, check whether the bearing has failed and whether the inner sleeve of the bearing is loose. If there is any movement, the bearing gap should be adjusted to the appropriate position, and sufficient sodium-based lubrication should be added to the bearing. fat.
10) Check the roll set frequently to see if the rolled sheets are loose.
11) When installing and replacing the roll sheets, the two sets of roll heads need to be separated by a certain distance, and there should be a certain gap between each set of roll sheets before the roll set can be installed and removed.
12) After replacing the roller or bearing, the hole pattern must be readjusted.
13) Before each replacement of the roll sheet, thin oil should be applied to the base, guide rails, gears and racks.
14) Every time you replace a roll sheet, iron filings and other debris in the entrance and exit holes of the frame and roll set should be cleaned.
15) Depending on whether the outer dimensions of the cold-rolled ribbed steel bars meet the standards, decide to change the roll.