(1) The installation foundation of the wire drawing machine must be very stable to avoid vibration.
(2) During installation, debugging should be done to make the tensile axis of the wire symmetrical to the center line of the die hole, so that the stress on the wire and the wire drawing die acts evenly.
(3) Frequent starts and stops should be avoided during the wire drawing process, because the friction caused by the tensile stress at the start of drawing is much greater than the friction during normal drawing, which will inevitably increase the wear of the mold.
(4) In addition, the wire used for drawing must undergo pretreatment: surface pretreatment and heat treatment.
