Before processing the wire drawing machine, the operator must carefully read the drawings and related technical information, and understand and grasp them. During processing, it is necessary to correctly select and confirm the drawing direction, drawing surface, etc., and operate in accordance with the regulations. It is also necessary to protect the surface of the workpiece to prevent it from being scratched and causing waste.
Products processed by wire drawing machines should be handled with care and maintained in layers to avoid damage to the products. The outside and surroundings of the equipment should be kept clean, tidy and hygienic; check the air supply pipelines, joints and abrasive belts to see if the contact is good and whether adjustments are needed; drain the water in the air filter and lubricate the bearing seats, etc.
In addition to daily maintenance, it is also necessary to check whether the tension of the conveyor belt and abrasive belt of the wire drawing machine is appropriate and whether adjustments are needed; whether the operation of the wire drawing machine is correct and safe to ensure that the wire drawing machine can always maintain a good working condition.
The wire drawing machine is used for general plastic wire drawing machines that have higher requirements for drawing gold wire. The entire system is relatively complex, and the control equipment requires coordination between the various motors. The system uses four servo motors to control the servo, which fully meets the real-time interaction between data and real-time data exchange between each group of axes.
In the system view that requires fast interaction between motor axes, in order to ensure that the track side lines according to the algorithm can be calculated quickly where the line of wires is required, we also make full use of the servo internal firmware function, calculated by the drive itself, The self-driving motor lines the line, which greatly eliminates the need for the traditional plastic wire drawing machine control system to calculate the line position, and then sends the time delay to the driver to ensure the line line to minimize the delay through the controller.
