When a flat wire drawing machine is used to draw products, defects such as coarse grains, fine sandpaper marks, and flow marks may sometimes appear on the surface. To prevent particles of dust from causing new scratches on the surface of the product, first, use an automatic flat wire drawing machine to dip 600# to 1000# water sandpaper into a small rubber lining block before polishing, and gently polish it until it is smooth. Be careful not to wear through the paint layer.
Then, use a machine grinder to add coarse abrasive paste to rough grind the traces of water sandpaper, add abrasive paste for polishing and fine grinding, and use a mechanical automatic flat wire drawing machine for wire drawing. In addition, by adding a mirror treatment agent to remove the marks left by the coarse abrasive paste, the polishing machine can achieve the effect of mirror polishing of the paint film.
After grinding and polishing, wipe off the grinding and polishing paste, immediately dip cotton gauze in varnish wax to wipe all the polished parts, and then use dry cotton gauze to wipe off excess glazing wax to make the paint surface as bright as a mirror and dazzling. The flat wire drawing machine is a precision metal wire drawing equipment with the characteristics of high degree of automation, high production efficiency and good wire drawing accuracy.
The flat wire drawing machine is suitable for precision wire drawing of various metal plates, such as iron plates, aluminum plates, copper plates, stainless steel plates, and flat fixed thickness drawings; it has three lifting methods, including manual and electric lifting and automatic fixed size. Fine-tuning the rise can make the workbench every step. Each time rises 0.1mm.
Before connecting to power, confirm whether the power supply voltage is consistent with the motor voltage, and determine the cross-sectional area of the cable based on the total power of the machine tool. The neutral and ground protection wires inside the machine tool are connected separately, and the shell of the machine tool is connected to the ground protection wire. Users should connect the ground protection wire to a reliable grounding device. Machine tools should be installed with good lighting conditions, and there should be sufficient distance between machine tools to prevent workpieces from flying out and injuring employees.
